Price: $12.00 - $6.89
(as of Dec 06, 2024 04:25:45 UTC – Details)
1* Solder Wire Spool
*Soldering Tips:
1. Heat up the soldering iron.
2. After soldering iron is fully heated, use a wet sponge to softly scrape the tip to remove old solder.
3. Wait seconds to heat and dry the iron, carefully apply a small amount of fresh solder and coat the tip for pre-soldering before start.
4. When soldering two components together, place the soldering iron on the part where you want to touch, hold it there for a second.
5. Slide the solder underneath the tip of the iron, sandwiching it to the joining part, and hold it for another second or two, feeding in enough solder you need.
6. Pull away the solder first, and continue holding the iron for another second to let the solder forming a good joint.
7. Remove the iron, wait a few seconds and let the solder natural cooling. A good soldering done.
【High Quality】High Quality Rosin Core Solder Wire, While 90% Lesser Slag and Smoke. Fits Various Kinds of Soldering Iron.
【Parameters】1mm 100g(0.22lbs) 63/37.
【Good electrical conductivity and thermal conductivity】Good solder ability both in electrical conductivity and thermal conductivity.
【Applications】Very good soldering capability, esp for circuit board, DIY, home improvement, Repairation of cable/TV/Radio/sterro/ Toys and other electrical devices etc.
【100% Satisfactory Service】 We provide 100% satisfactory after-sale service, if you meet any issue or you are not satisfied with the product, please feel free to email us. We will provide 100% money refund.
Monday
7am-3pm
Tuesday
7am-3pm
Wednesday
7am-3pm
Thursday
7am-3pm
Friday
7am-3pm
© Copyright 2025 | PCB Repair
YukaDecember 6, 2024
Works as expected
Works as expected
Angie and her husbandDecember 6, 2024
Where was this stuff?!
Makes soldering a breeze, wish I had started with this!
The LowdownDecember 6, 2024
Did the job
Flowed Nicely
Victor m VillalobosDecember 6, 2024
Simple and easy melt
Fast shipping, good product, melts quickly
TD HANSONDecember 6, 2024
SOLDER WON’T FLOW BUT BEADS UP
HEADLINE TELLS IT ALL. FLUX CORE & FLUX DIP MAED NO DIFFERENCE
JimDecember 6, 2024
not good
Worst solder joints I ever did. I cringe everytime I have to use this junk. It stinks up the room and doesn’t melt well. It refuses to flow, and all the impurities leave crap all over your tip. Do NOT use for fine work on boards. It will ruin your project..
Jenna B.December 6, 2024
Not what you think
Doesnât melt well, seems bare minimum and wasnât happy with it 🙁
WhryDecember 6, 2024
Very cheap solder
Goes from ehh to crinkly tin in about 5 seconds with iron set to 380 degrees f